Dennys Bisogno

  • Total activity 145
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 2
  • Subscriptions 73

Activity overview

Latest activity by Dennys Bisogno
  • Dennys Bisogno created an article,

    Differences between Omniscan 450 SS and Omniscan 450 SS (Blue Boat edition)

    The functionality of the Omniscan 450 SS is the same whether you purchase the standard or Blue Boat version. However, there are a few notable differences in the KIT.   Cables KIT for Standard Omnis...

  • Dennys Bisogno created an article,

    What are the ROV Locator wiring instructions

    You can locate the ROV Locator wiring instructions on this section of the manual.  

  • Dennys Bisogno created a post,

    From our Friends at Coastal Sensing & Survey (Seattle)

    Imaging generated from two Omniscan 450 FS

  • Dennys Bisogno created a post,

    From our friends in Southeast Louisiana Underwater Search and Recovery

    Testing the Omniscan 450 FS on an Outland 3000 vehicle.

  • Dennys Bisogno created a post,

    ROV Rescue - Omniscan 450FS

    July 2023 : BillyBudd In this video I use a BlueROV2 to recover a submerged hull cleaning ROV. First time I’ve used Omniscan in the wild and super impressed with the results. Even for a complete am...

  • Dennys Bisogno created an article,

    What is the maximum range of depth for the Sounder S500

    While the S500 maximum range depends on the type of bottom or target being ping, the device has 142m in the firmware. That is not necessarily a hard limit but a good estimation.

  • Dennys Bisogno created an article,

    What are the OS450 power requirements

      10-30 Volts, 5 watts max at idle 10 watts max while pinging.  

  • Dennys Bisogno created an article,

    Doppler Motion Tracking and "Position Hold" without a DVL

    Using only two channels (as opposed to a full DVL, which would have at least 3 or 4), there can be a slow drift in position hold mode (typically 1-2 meters/minute.)  

  • Dennys Bisogno created an article,

    Is Omniscan Doppler motion tracking as accurate as a DVL

    Omniscan Doppler speed measurements are not as accurate as a DVL due to the ambiguity of the angle of the reflected signal. Nevertheless, it is accurate enough to give excellent situational awarene...

  • Dennys Bisogno created an article,

    Doppler Motion Tracking "doppler ping," and image quality

    When Doppler Motion Tracking is enabled, the imaging ping rate is reduced by half, where you may notice some decreased image quality. Doppler Motion Tracking can be enabled and turned on/off with a...